Pre-ride check: A two-minute walk-around that can save your life
Most breakdowns and many crashes start with something you could have spotted before you moved off. Make a short, fixed routine and do it every time.
Walk round the bike
- Look under the bike for leaks, fluid spills or anything in the way.
- Work around the bike the same way each time, from top to bottom and left to right, so you never skip a part.
- Check that lights, lenses, reflectors, mirrors and the number plate are clean, secure and undamaged.
- Confirm that your registration, licence disc or inspection sticker is valid and visible, where your country requires one.
- Check both tyres for tread depth, cuts or damage, correct pressure, valve caps fitted and any oil or grease on the rubber.
- Look at the brake discs, forks and shock absorbers, and mudguards for wear, damage and leaks.
- Check the controls are secure and work correctly: gear lever, foot brake, brake and clutch levers and cables.
- Check engine oil, coolant and brake fluid levels.
- Check that body parts are secure: footrests, exhaust, fuel tank and cap, side covers, chain guard, seat, radiator, windscreen and fairings.
- Check that the chain is correctly adjusted and lubricated, and that the fuel cap is closed.
- Check the battery for damage, security and fluid level where it has one.
Then, from the seat
- Switch the ignition on without starting the engine and watch the dash: warning lights should come on and then go off normally.
- Test the lights and indicators, horn and brake light, then switch everything off.
- Check the throttle turns smoothly and snaps shut when released. If there is a kick-start, make sure it is stowed and moves freely.
- Adjust both mirrors with your hands so you can see well to the rear from your riding position.
Tip: If something is faulty, do not ride and hope. Fix it first. In a licence test, an unroadworthy bike usually ends the test.