Motorcycle maintenance basics: small jobs that keep you safe
A well-kept bike is safer, cheaper to run and easier to sell. Most of the basics take minutes. Always follow your owner's manual: it gives the correct pressures, fluids, intervals and specifications for your bike.
Tyres
- Check pressures cold, at least every week and before long rides, using the figures in your manual.
- Look for cuts, bulges, embedded objects and cracks. Replace worn or damaged tyres. Tyres also age, so very old rubber needs replacing even with tread left.
- Check the tread against the wear indicators. A small contact patch makes tyres your most important safety item.
- Keep valve caps on and look at the wheels and spokes for damage.
Chain
- Clean and lubricate the chain regularly, and after riding in rain or on dirt.
- Check the slack against the manual. Too tight wears the sprockets and bearings. Too loose can derail the chain.
- Check the sprockets for hooked or worn teeth, and replace the chain and sprockets as a set.
- A shaft-drive or belt-drive bike has different checks: see your manual.
Engine oil and coolant
- Check the oil level with the bike upright, as your manual describes, and top up with the correct grade.
- Change the oil and filter on schedule. Old oil wears an engine quickly.
- On a liquid-cooled bike check the coolant level when the engine is cold, and look for leaks.
Brakes
- Check the pad thickness and replace the pads before they wear to the metal.
- Check the brake fluid level and condition. Fluid absorbs moisture and should be changed on schedule.
- Levers should feel firm. A spongy feel means air or worn components, so have it checked.
- Check the rear brake pedal travel and adjustment.
Battery, lights and cables
- Keep battery terminals clean and tight. If you ride rarely, use a battery tender.
- Check all lights, indicators and the horn, and carry spare bulbs or fuses where relevant.
- Lubricate cables and check that the throttle snaps shut. Check the clutch and brake cables for fraying.
A simple schedule
| When | What to do |
|---|---|
| Every ride | Quick walk-around: tyres, lights, leaks, controls. See the pre-ride check. |
| Weekly | Tyre pressures, chain lube, oil and coolant levels. |
| Monthly | Chain slack, brake pads, battery terminals, cables. |
| At each service interval | Oil and filter, air filter, spark plugs, brake fluid and full inspection, as in your manual. |
| Yearly | Full service, tyre age check, brake fluid and coolant per the manual. |
Washing and storing your bike
- Wash gently and dry it, avoiding high-pressure water near bearings, electrics and the chain.
- For long storage, use a clean, dry place, a battery tender, a fuel stabiliser where recommended, correct tyre pressures and a breathable cover.
- Before riding again after storage, do a full pre-ride check, with extra attention to brakes and tyres.
Tip: Keep a small notebook or phone note of service dates and kilometres. It helps with servicing and adds value when you sell.